Anycubic Photon Printer Owners 造訪社團

Two questions for you all with more experience.

1: Is there a resin that cures a little closer to say forgeworld/gw resin models? A little more soft when going at it with an xacto?

2:Can some of you share your support settings? I am using Chitubox(I know Prusa is highly recommended but I have yet to figure it out haha). I was tinkering with my settings and now my supports seem to be leaving a little bit larger marks to clean up, hoping someone has some good suggestions. I mainly use Elegoo 3d rapid Grey(is this also what everyone refers to as Elegoo Grey or are there two versions?) and have two bottles of Siraya Tech Blu to try, if the resin types matter.

Thanks!

翻譯年糕

Came out to clean my printer today and noticed that there LCD was cracked.has anyone changed the glass or display?

翻譯年糕

Those hips.. ?

翻譯年糕

After much adventure, my USB port failure seems to be solved. It appears the screws holding the port in place were loose (received that way from the factory, so check your screws), allowing the port to shift slightly whenever a drive was placed in it, causing a faulty connection. So, if you encounter a USB issue like mine, check there first.

翻譯年糕

Anyone have any experience with custom-built filtration for the Photon? I've seen a printed solution for using a filtration tube to redirect fumes outside. Anyone done airtight containers? Or any other creative solutions?

翻譯年糕

My own ghetto DIY cure chamber! Almost done! You think it’s overkill?

翻譯年糕

Has anyone tried the Esun high precision resin for printing minis? I'm generally happy with my Elegoo grey but now I'm looking for something that can provide slightly better detail. I've also heard good things about Siraya Blue mixed with Esun resin. Opinions are appreciated.

翻譯年糕

Hi everyone, i have an issue only you can help my fix. I print supportless miniatures for D&D, but i don't really like to smack the s*it out of the print to detach them from the plate, so i made my own with a little bevel to make it easer. So far it works pretty well, but the minis i print with my own flat base always took some of the minis inside, the picture is pretty clear. Of course the file seems ok, but it's like the base keeps getting printed and so it covers the feets ecc... I think it's something about exposure time maybe, but i'm really not sure. Can you help me with this? Thanks a lot

Btw these are the bases
https://www.thingiverse.com/thing:3454187 翻譯年糕

I am going to enclosure my photon s here and will have an exhaust fan for the air, this is the beginning of the project.

Hope today I will finished

翻譯年糕

Does the new photon s firmware P_V341 support Chitubox?

翻譯年糕