Hey guys,
I didn't print anything on my photon in like 2 months and started printing again using a new bottle of Anycubic Grey. So far I only used Anycubic Green (translucent).
But I really struggle with this grey resin. I'm getting strange artefacts on my prints, that appear randomly on certain layers across multiple minis. I also have some goop sticking to the FEP. They are like flakes and can also be found on parts of the minis.
I also noticed that some parts of my prints such as the wolf's paws or the feet of the goblins merge together with the base or are flattened out. I tried doing an exposure test previously, and also had these artifacts. Due to not perfect leveling I didn't use the exposure test results and releveled first.
Could it be some mechanical failure like light leakage?
I took the exposure settings from the spreadsheet.
0.05mm layer height.
18sec exposure
1sec offtime
base layers 90sec
8 base layers.
I reduced the exposure to 14 later, since i saw some posts of people saying the exposure was far too high on the spreedsheet, but the results were the same.
The fep was very tight, maybe even too tight. I will replace it for a testprint with the remainder of my anycubic green.
翻譯年糕
