Here's a model and 3D print I did on my Photon at the end of 2018, as a Christmas gift for my brother. Mechanical parts in 3dsmax, character in ZBrush. Hollowing and vent hole added in ZBrush before doing supports in ChiTuBox.
Printed in AnyCubic White, with these settings:
Layer thickness: 0.05mm
Normal exposure time: 12s (I think this overcured a bit, I will try 10s next time)
Bottom exposure time: 80s
Bottom layers: 6
It mostly came out alright, unfortunately something got messed up during slicing (using AnyCubic Photon Slicer64) that I didn't notice until the print - parts of the interiors of the wheels got skipped, it appears to be a bug with the slicer since the STL is fine.
I originally thought it was a print error, but I went back and looked at the sliced file layer by layer and there were entire sections missing, even though the 3D model contains valid data there. I might try again at a different orientation and see if the same thing happens, as it's pretty odd. Maybe there's some topology there it didn't like.
Photos show:
1. 3D model in ZBrush
2. Raw print before cleanup, after support removal
3. Cleaned up and primed with Tamiya Gray spray primer
4. Painted with Tamiya paints (just brushed, I don't have an airbrush)
I put the model up on Sketchfab too, in case anyone wanted to see the original sculpt:
https://skfb.ly/6FRvL
翻譯年糕
Zena Andreou
2019-01-02 01:20:59
Baturalp Arslan
2019-01-03 05:49:04
