Anycubic Photon Printer Owners 造訪社團

Could use some help troubleshooting a recent Anycubic Photon problem: Relatively new machine, only had it about a week and only done a handful of prints on it. The last three prints have all had this problem (see pics below). On one side of the print, the support struts don't seem to print at all, and the resulting drag on that end ruins whatever was supposed to be supported. Also (harder to see), but the models are getting imbedded in the raft, even though they're well elevated above it when we slice out the image. What's annoying is that half the model looks perfect, like everything is working fine on the right side of the miniature but screwed up on the left. We're very new at this sort of thing, and would love any help. Thanks!

翻譯年糕

@ Giancarlo Arriola - Since you asked... This was the first video test to see what we needed to tune.I think I need to add some additional lighting. I tried to put a finished example in the center with a coin for size reference, unfortunately with how the camera was positioned it focused on the center when there were smaller pieces and then back. I'll probably just have to put it into the circle along with the rest of the pieces to keep focus in one area.

For the comparison tests, we've picked one model which will be done at its original size (32mm scale) and then one done at 2x the size. We will compare various SLA and DLP printers, using different resins. For the resins that allow us to adjust print resolution we'll do various examples, like 25, 50 and 100um test then do a side by side video to compare. Some resins like the EnvisionTEC only allow 25um. I will be doing the raw pieces, which is after they were printed and gone through IPA bath without any cleanup. Then we'll do cleanup on them and then finally do a completed piece. Then we'll do a video comparison with them primed. There will also be comparisons of multi-piece print vs printing as a single piece. For example the peach miniature in the middle was printed as one piece at 25um (DLP), while the other pieces were done at 100um (SLA) multi-piece.

Not sure how we'll do the final composition, do it as one video or just segments. This is just a test, figured I'd show a sneak peak.

翻譯年糕

Done this one some time ago but like the light saber effect.

翻譯年糕

Supports for DLP Printing:
So, I can tell when a FDM print will need supports, im new to DLP and excuse the novice question, but with DLP, would it be safe to assume that if a FDM print would need supports a DLP print would need them too? Or does DLP have lesser or stricter needs for supports?

翻譯年糕

Anyone know of any replacements for the piece that holds the build plate and attaches to the z rod? I think mine is ruined

翻譯年糕

Test print is a go!

翻譯年糕

Uva or uvb? Or does it matter? Uva or uvb? Or does it matter? 翻譯年糕

Latest Duncan Louca's sculpt not easy To take good pictures of the fine details because it look like a ice statue, done with a mix of Monocure Flex100 and Rapid clear ratio:50/50. Washed with ResinAway To keep it clear and not cloudy.

翻譯年糕

I am falling behind on painting the stuff I have been printing. At least they have some primer on them.

翻譯年糕

I know it’s not finished and it’s not a Photon but this is the route I decided to go since I am one of the fume paranoid types. It will be venting to the outside world. I’ll post more once it’s finished if you guys want.

翻譯年糕