Anycubic Photon Printer Owners 造訪社團

Hello someone has settings for this Cast resin

翻譯年糕

Experience about ultrasonic cleaner? Someone’s that is to bad, to low power or something special I should look for?
Have this in mind and fill it with ipa https://www.kjell.com/…/ultraljudstvatt-cd-4800-70-w-p40491…
https://www.kjell.com/se/.mvc/Document/File…

翻譯年糕

Hey guys, any advice, I tried doing some prints (simple flat quality of life misc parts) and I tried placing them directly on the plate - what I noticed bottom 3mm or so well quite deformed - almost shrunk down - as that area looked like z-axis wasn't uniform - linear? It was specially affected round shapes that became flattened /oval. Interestinglu over 10cm there is no warping.
After that I noticed on my bigger prints same thing - the layers close to the plate are distorted - and the slicer doesn't allow to increase then z-position over the built plate *eyeroll*

翻譯年糕

Has anyone use to encounter this problem. I install photon slicer but could not find the basement of the printer. I try to move mouse around. there is not base hidden,

I try to install 3-4 times with difference version. But still have problem

翻譯年糕

Morning all, does ny one have suggestions on how to support this model?

翻譯年糕

It's possible?

有可能嗎?

· 查看原文 · 為此翻譯評分

Hey guys, I've just bought my printer, and done the test print. Loving the community here so far!

Just have a quick question: Is there alternatives for the little paper filters for pouring back into the bottle? I feel like a sieve that would get washed in alcohol afterwards would be a lot less wasteful.

翻譯年糕

Hey, guys what do you think about this printer ? I have photon, but looking for 4K upgrade. Has anyone had any experiences with it or has a suggestions ?
https://www.aliexpress.com/…/Tianfour-new-…/32912506610.html

This was the largest DLP printers group so I posted there

翻譯年糕

I want to start painting some prints, have compressor and printer, what airbrush is recommend and which paints? Any howto videos on the subject.. im bored..

翻譯年糕

My test-print with one month old resin (resin was loaded one month in VAT without move):

翻譯年糕