Anycubic Photon Printer Owners 造訪社團 » 用戶發文

(Note: I am printing 28mm figurines for role playing) Does temperature affect the resin and the ability to print? Recently, with the temperature drop, I am finding that I cannot print past the layer that binds to the aluminum plate. The support layer prints and binds to the aluminum plate just fine, but I cannot get the machine to print the supports leading up to the models base. If temperature can affect the printing, what is the solution?

翻譯年糕

What device would people recommend to cure the resin after printer. I put a dot of resin into my current machine and after about 30 minutes, it is still wet. I am assuming I don't have the correct UV light.

翻譯年糕

Question. If I create a single model and 3d print it, everything comes out fine. If I duplicate this model to print 6x at a time in Anycubic Photon Splicer, it prints the base and then everything sticks to the plastic at the bottom of the tray. Do I have to change the cure time or other settings if I go from 1 to multiple models? I would not think so, but my knowledge is limited at this time.

翻譯年糕

So I printed a 'group' and I guess I did not put the supports in correctly. Now I cannot get the models off the base plate. How would you suggest getting the print off the base plate?

翻譯年糕