Anycubic Photon Printer Owners 造訪社團

GAZ 47

New lifting problem solved. I print enclosures flat on the build plate. As I have said several times in this forum, you can do that without a problem if you use vent holes to avoid the suction problem. Well, the past few days I've been chasing a problem with the front edge of my prints lifting off the platform. At the worst, it shredded the front of the model. At the best, the bottom was just lifted a bit. Without going through all of my debugging efforts, I can tell you exactly what the problem was.

I cleaned the glass. I noticed the area of the glass, under the tray, was a little cloudy toward the front, which is where I was having the problem. It definitely was not enough to affect the light; I've had worse on the film. I'm almost positive that it was causing the film to stick to the glass. Before cleaning, I was getting a mild peel sound, which I chalked up to other factors. After cleaning, I got the nice loud popping sound, like just after I replaced the FEP film. I think the dirty glass was inhibiting the FEP film from stretching up properly, which caused peeling issues. My print came out perfect after cleaning.

If you are struggling with adhesion problems and you think you had everything dialed in, I suggest giving the glass a good cleaning. I just alternated between a paper towel moistened with IPA and a dry paper towel until there no streaks left.

翻譯年糕

PSA: The most recent firmware update has changed my offtime minimum from 6.5 to 4.5.

2 seconds over thousands of layers is a significant reduction of print time. Take this information as you will.

翻譯年糕

Prints well, and is castable, will cast a few and post result tommorow.

翻譯年糕

Hi all, quick question on pausing prints on the Photon. Would it be best to pause when build plate is going up?

I'm worried about ruining the print or introducing artifacts, but I need to check as my print times increase.

翻譯年糕

Hola!
Alguien puede compartir los parámetros para las diferentes resinas?
Saludos y muchas Gracias.

翻譯年糕

Duncan Louca's sculpt.

Who is using White Wanhao Resin ?
I’m using those settings

翻譯年糕

Who is still using the well known fix from this group with a gorilla glass and some electric tape to protect the screen from "stycky vat" damage ? Anyone had problems with it like, adhesion problem with some very liquid brands of resin ?

翻譯年糕

Question guys!

Anycubic resins! - the pigmented ones require more exposure as the pigment absorbs the UV radiation.
So if I always end up priming the models anyway - what is the point of them and not using just a clear resin with which I can print the fastest?

Are there any strenght characteristics betweeen Anycubic resins?
Next month I want to give a go with PhotoCentric ones.

翻譯年糕