Anycubic Photon Printer Owners 造訪社團

Near full plate. Looks 100% complete

翻譯年糕

Why do prints curl on the 1side off the buildplate...is it levelling? Why do prints curl on the 1side off the buildplate...is it levelling? 翻譯年糕

I like to print voronoi style with anycubic photob. Small and big printed together

翻譯年糕

Wasn´t here a document with all the different settings for the different types of resin? I can´t find it. Thanks! Wasn´t here a document with all the different settings for the different types of resin? I can´t find it. Thanks! 翻譯年糕

Hi Guys,
after a week of use, my experience with the photon is very bad. The prints are amazing, but the dimensions is very out of tollerance, specially in xy. I think there is a problem in the calibration. Is there any trick to make the plate planar?

翻譯年糕

3rd print with the anycubic green. Overall very happy with it. There are obvious layer lines and a file-like texture.

Settings: 0,05-10-1-50-8

Still learning so any tips on setting adjustment will be most welcome :)

翻譯年糕

How long takes for a anycubic resin order to be delivered to Eu from Germany?
I placed the order 24of September.

翻譯年糕

Hi, I'm new to this forum and I would like to know where I can buy the green resin that comes with the printer, I bought the red one but I do not like the result much the green is much better, or if someone has used the red one what values ?

翻譯年糕

Small update from my prints with ameralabs AMD 3 led resin. So far so good still trying to cure the resin I only have the sun so far to cure with. Here are my latest prints uncured.

翻譯年糕

I'm trying to get a bead on best practices for printing D&D miniatures with my Anycubic. I just got it a few days ago and I'm pretty sure I've scuffed up the film enough that I'll need to replace it soon, but I'm trucking along.

Does anyone here have experience with doing printing D&D minis with their Anycubic?

So far, I've tried two approaches:

* Printing with base on, vertical, generating supports from Meshmixer. This has worked well for a number of minis, but others have turned up limbless or otherwise deformed.

* Printing with base off, supports generated by the Anycubic Photon Slicer. This was a pain in the butt to get off of the build plate and most of my minis turned out various degrees of screwed (usually in early layers).

I've been doing FDM printing for a while, but I'm not 100% up on the lingo or the practice of resin work, so I'd appreciate any help I can get. (And no, I'm not playing with the resin right now using my bare hands, I promise.)

翻譯年糕