Anycubic Photon Printer Owners 造訪社團

Trying to update firmware. While clicking on 255.lcdimg
it shows unknow file format

翻譯年糕

https://www.kickstarter.com/…/the-lost-dragons-3d-printable…

what do you guys think of this idea of using USB heat pads around the vat to keep the resin warm?

UPDATED WITH PARTS LIST FOR VAT HEATING..

Simple tape this with kepton tape around the build plate.

Feels like it could be a cheap and feasible option, my only concern is running this for hours on end would probably cause a fire.

Has anyone come up with a solution for direct resin temperature heating?

Obviously a heater will work to heat the entire machine, but thats not great for the electronics and wastes electricity.

https://www.ebay.com.au/…/5V-usb-Insoles-heat…/253805708190…

翻譯年糕

Hilarious video comparing IPA vs Resinaway. Well done! ? ? ? ?

翻譯年糕

Always a nice feeling when you wake up, grab a coffee, go check the printer and .... bits have become atoms ?

翻譯年糕

Hey group, I've been having some issues here and there with supports being generated too close to the model, which essentially ruins the entire print. Any tips for how to have the supports generate further from the model? Any settings that make this smarter? Hate seeing big prints like this ruined to supports bleeding into the detailed surface.

翻譯年糕

So this is my 3rd printer in a year i have loved them all started out with a anet A8 modded to a AM8 works very well after tons of work and mods. Then wanted bigger got a Tevo tornado very little work and it printed like a champ. On a whim I gave into the urge for another printer deciding to give a resin printer a go. Holy expletive this thing was the easiest to set up and get first print going and came out like a champ from open to printing in about 20 min. Took a little bit longer than it said it would be but if you have used any other printer you know that's going to happen but came out damn near perfect. have to say very happy.

翻譯年糕

ok so earlier in the week i had problems in my print with little ledges on the surface that are flat, that do not show up in the slicer, i ran the web program and clearly it shows they are there, I have tried every resolution and angle i could think of to fix it. with no success, ive attached some pictures, i am truly lost on what i can do to correct the issue.

翻譯年糕

Hi hive mind, I have two questions;

1) can I get spare/replacement spatulas?
2) can I get spare platforms?

Cheers, Ben

翻譯年糕

Hello everyone. I wonder what's is the best way to remove the supports. I used a nipper and a scalpel after the IPA clean.

My best regards

翻譯年糕