Anycubic Photon Printer Owners 造訪社團

On level how much resistance should paper have?

翻譯年糕

Should i print it even with these errors. I don't think it interferes with my model.

翻譯年糕

Home sensor imprecise? About half of my prints fail (Ok, now I have a feeling about it after the first layer, so not too much time loss, but anyway). Typically, after homing, I have to go down 0.9 mm to have perfect distance. The stepper motor then loses some steps when going to z=0, which make a typical rumbling noise. Normally uneanted, usually for me this is good; all these prints succeed. But sometimes even after going down e.g 1.1 mm, this sound is missing, prints stick to the FEP, and there is too much of a gap between FEP and platform. Especially my Anycubic Gray needs tight leveling. Seems that the light does not penetrate deeply. So my conclusion is that homing is imprecise. Did somebody experience the same? Cheers

翻譯年糕

could anyone using photon for dental aligner or orthodontics work.what is the benefit traditional vs digital .could anyone tell me how people using sla or dlp printer for dental work ?

翻譯年糕

Can somebody tell me the trick to how to set your models height above the build plate and make it stay that height when using auto supports?

Basically, I set a model to say 5mm above the build plate but when I generate my supports and go back to the previous tab, the supports aren't 5mm high anymore, they are shorter.

I've heard of people doing this I must just be missing a setting somewhere.

翻譯年糕

So after giving the printer double the voltage by mistake,thanks to the crappy power brick that comes with the printer, it seems like the screen was fried together with the fan....any recommendations for a new screen? Do you think that the screen is ok but is the mosfets that are fried?

翻譯年糕

first printing not successful! everything remained in the bottom of the tank. z adjusted badly?

翻譯年糕

Hi, is there any other slicer I can use with my Photon? I use Simplify3D for my Prusa, is it any usable for Photon?

翻譯年糕

Thought people here might have an interest in these. I am going to have these lapel pins for sale in a few weeks, $10 for 1 or $15 for 2 with free shipping in the U.S. they are 1.5” long

翻譯年糕