Anycubic Photon Printer Owners 造訪社團

Zbrush sculpted brooch based on my mother's oil painting, Anycubic Green, default settings at .02. Details came out nicely.
I used fine supports and had to be very careful removing them without damaging the delicate parts, did this before UV cure.
CG Tuntable > https://www.youtube.com/watch?v=QjHEqjRsHwU

翻譯年糕

Hello folks - two questions that I hope you can help me with.

1 - What alternatives are there to IPA. I am struggling to find +70% proof in the U.K.

2 - it’s really hot here at the moment and I am finding that even taking the resin out of the printer is causing it to harden instantly and that’s making a mess out of the tray. What suggestions do people have to removing the hardened resin from the print tray and print bed?

Many thanks!

翻譯年糕

Hey guys, I've been using my Photon for more than a week now and I've already achieved some amazing prints. However after leaving resin in the VAT, where sunshine could reach it, I had to clean the VAT completely and replace the FEP film.

After doing so I tried to print the Coloseum and a watchtower at the same time and it didn't turn out great.. The watchtower didn't stick to the buildplate and the Coloseum is messed up as you can see in the pictures.

Is there anyone who could tell me what might be the problem?

翻譯年糕

I was trying for a glass effect using monocure 3d. I washed with 99% IPA and put under a 405nm UV lamp. Any suggestions as to how to keep the clear glass look from strait out of the printer?

翻譯年糕

I got my Photon on Friday and although I've managed to get some decent prints I'm afraid to say that I have the "Z wobble" issue.
I've tried the Z wobble fix and so far it's not improved a thing, I also tried loosening the screws that hold the stepper in place but I can still see ripple.

When I attempted to adjust the eccentric wheel on the slider I noticed that looking from above the slider was pushed out at one side by about 1.5mm - any ideas what I'm doing wrong or is it just a case of having the eccentric wheel being set too far from the other wheels?

翻譯年糕

First set of lenses off the photon.

Monocure clear 0.5/60/8/10/1.

翻譯年糕

Has anyone tested this resin, how its castebility???

翻譯年糕

Hmmm.
Where to get as fast as possible new FEP-Foils in europe/germany?
Or are there alternatives?

翻譯年糕

After 6 months of practically non stop use. Looks like my lcd has finally gone kaput. It would happen when I have a handful of orders to do too!

Anyone know where I can get a replacement and which part I actually need?

翻譯年糕

Would you recomment the Anycobic Photon? I am looking into buying a DLP Printer

翻譯年糕