• 3D列印服務
  • COSPLAY 3D 建模
  • #maker+t=market
  • 1
  • 2
  • 3

ATOM 3D Printer Group 造訪社團 » 用戶發文

原文網址 Gbb Technics
2020-01-26 23:41:47

Hello everybody,

I would to present to you the different steps of my ATOM 2.5EX printer evolution project:

- Step 1: disassembly of internal electronics + addition of TOP LED rails for lighting (Status => 100% finished)

- Step 2: replacement of the 8-bit motherboard with a 32-bit board (Duet2 Wifi) + addition of Side LED rails for lighting (Status => 100% finished)

- Step 3: development and integration of a 7' paneldue screen on the frame with laser-cutting aluminium parts + folding (Status => 75% finished)

- Step 4: manufacture of a rear plate to integrate the antenna of the Duet2 Wifi board + addition of an inter-switch for the internal lighting of the printer (Status => 75% finished)

- Step 5.1: replacement of the original nozzle with an 24v e-3D v6 standard version + a 24v Dragon Hotend version (Status => in progress 75% finished)

- Step 5.2: developpement and integration of a PCB for rapid disassembly of the print head, it's the same principle as ATOM 2.5 FX (Status => PCB are 100% developped and PCB manufacture is 50% finished)

- Step 5.3: replacement of the 12v power supply with a 24 volt version from Meanwell. (Status => to be mounted)

- Step 5.4: installation of a 24v to 12v converter to keep the original heating bed in 12v. (Status => to be mounted)

- Step 6.0: finishing integration of the 2 DYZE Filament sentinel to be able to stop the print when wire is out.

- Step 7.0 : integration of the ATOM laser module (if possible with the Duet2 Wifi). For this last step, I'm not sure if I can connect and run the laser on the Duet Board. I need to check first...

I will give you news about my project in few days / weeks...

翻譯年糕

Samuel Chiou
2020-01-26 23:50:06

Cool!

John Wachowski
2020-01-26 23:56:19

Looking good!

Charlie Ting
2020-01-27 03:20:52

Step 5.4? converter or switch power?

Gbb Technics
2020-01-27 03:42:53

Charlie Ting I will try to use a power Converter from 24 to 12v for This.

Ash Fletcher
2020-01-27 14:20:01

Wow that’s a nice up grade. I would like to do the e3d upgrade . That would make it nice to clean out the nozzle


原文網址 Gbb Technics
2019-11-20 06:38:58

Hello,

Is anyone already switch original motherboard to 32 bits motherboard with Marlin 2.0 firmware on ATOM 2.5EX ?

I would like to replace my original board by SKR V1.3 motherboard or SKR Pro v1.1.

This is a project for the moment, but I think other people have same idea...

Thanks for you answer

翻譯年糕


 

全不選 常用關鍵字