ATOM 3D Printer Group 造訪社團

電線接觸不良？

Relay造成的反電動勢！？

電源瓦數不夠嗎??

老師wwwwwwwwwww

一擊必殺的皮卡秋？！

你怎麼了!! 皮卡稱....

影片主人 有在這社團ㄟ！ 高手來著的...

好想知道是誰啊 XDDDDDDDD

http://www.thingiverse.com/thing:1431085

@_@

皮卡玉!?

可能用了合體之術..XD

這個不是你要的？
http://roestudios.co.uk/project/3d-pokemon-models/

http://www.thingiverse.com/thing:177222

前些日子還有網友分享的不錯喔，還可以把小孩弄哭弄笑…XD

nice design!

Nice!

geckotek is nice, too.

Configuration.h

# define DEFAULT_AXIS_STEPS_PER_UNIT {160, 160, 160, 200}

I only have to change the last number ?

because I changed it to 800 but it didn't extrude further

Thanks

Restore failsafe

actually those value could be changed via LCD menu directly

ok I will try

I have seen some values connected to extruder config in Configuration_adv.h

I thought it might be a better option

the DEFAULT_AXIS_STEPS_PER_UNIT {160, 160, 160, 832} is the perfect set for the titan extruder but now the motor skips steps and it doesn't turns continuously although the amount of extruded filament is right. Is there any other config that can change this motor step skipping ?

# define DEFAULT_MAX_FEEDRATE {300, 300, 300, 500} // (mm/sec)
#define DEFAULT_MAX_ACCELERATION {3000,3000,3000,10000} // X, Y, Z, E maximum start speed for accelerated moves. E default values are good for skeinforge 40+, for older v ersions raise them a lot.

#define DEFAULT_ACCELERATION 500 // X, Y, Z and E max acceleration in mm/s^2 for printing moves
#define DEFAULT_RETRACT_ACCELERATION 9000 // X, Y, Z and E max acceleration in mm/s^2 for retracts

thank you, it still skips a little bit but it is much better !