Looking for some advice on an issue I'm having with my printer. All my prints come out stretched. And I'm out of idea's. To clarify: Prints made in the pictures below, I've used FEP sheets and grey resin by Anycubic. No other brands. Below are the settings I've tried with the resin/sheet.
Exposure time: 12/13/14s
Off time: 6s
Bottom exposure: 90/95/100
Bottom layers: 8/10
First off, I've contacted Anycubic with the first five pictures attached. Stating that my prints were stretched. At first, I was worried my stepper engine was failing. Anycubic advised me to use a new FEP sheet and tighten it according to the manual. I did so. No results. Unfortunately, I damaged my sheet and screws from the resin tank while testing. Anycubic helped me out by giving me a discount for buying a new tank.
Bought a new one, used it straight out of the box. But the problems persist. Every model is stretched. As you can see with the Spider-Man for example. (Spider-Man is hollow btw) The other example is supposed to be a square plate.
翻譯年糕
Zena Andreou
2019-02-17 19:12:41
Ilja Ilmar
2019-02-17 19:20:40
Dennis Verhoeff
2019-02-17 20:48:41
Dennis Verhoeff
2019-02-17 20:48:49
Dustin Skye
2019-02-17 22:53:16
Dennis Verhoeff
2019-02-17 23:49:37
Dustin Skye
2019-02-18 00:12:06
Sen Kun
2019-02-18 02:01:54
Stefan Giudici
2019-02-18 03:43:56
Stefan Giudici
2019-02-18 03:44:42
Eric Jensen
2019-02-18 03:59:56
Dennis Verhoeff
2019-02-18 04:37:24
Sen Kun
2019-02-18 04:46:00
