Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Just sharing:
I started up my photon with a USB stick formatted in exFAT in the printer. (I had used it for something else earlier and reformatted it)

It turned out that the photon froze, or rather got some strange behavior on the touchscreen.

I restarted without the USB and it seemed fine, so i reformatted the stick in FAT32 and now it works fine again.

Is this a known issue?

翻譯年糕

So i see people talking about mixing resins...

Is there any pros and cons?

Iwas wondering since i've got some of anycubics resin left, but use monocure right now. Not a big issue, but it seems like a waste to just throw stuff away...

翻譯年糕

Still lots of layer lines.
The loss of details is another thing in this print since My son cleaned with water before the IPA...

翻譯年糕

My first problem seems to have disappeared... Dont know how...

But now i cant seem to get the prints quite as i want them.
I get visible layers at 0.02 layer height (13s/1s, monocure rapid black) and some layer shifts that i fear is z wobble

翻譯年糕

As I was guessing earlier I seems like the photon prints a single full layer some time into the print... This time it stuck to the print so I could see it clearly.

First I thought it was me that forgot to run the print mode file after the exposure test. But I really did do that.

翻譯年糕

Can leveling too close give an elephant foot? And can it make the print stick to the fep?

翻譯年糕

Can't get the machine to work properly...
0.05 layer height 12 seconds 80 seconds on 4 bottom layers.

It seems like a film of resin is clinging to the prints... Like it prints a full screen that is not attached to anything and then clings to the print and to the fep...

Tried starting without vat and plate just to see, but it seemed fine. Just tested the first 10 seconds though...

The residue on the fep doesn't match the print at all.

翻譯年糕

So i got a 0,5l bottle and a 1l bottle of monocure standard resin.

Can i use it in my photon, or should i just throw it away?

翻譯年糕

I'm not goint to print anything for a few days, so i'm told to empty the vat back into the resin bottle.
That´s all fine, but how do i clean the vat?
Can i use ethanol in the film? Anyhing to recommend or avoid when cleaning?

翻譯年糕