Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Kurk Watson
2019-06-27 10:00:36

Hey crew, is alcohol the only counter chemical for resin? I ask this as some was spilt on pavers infront of my home from garage collection and has set from UV rays leaving a horrible red stain.

翻譯年糕

Ryan Cook
2019-06-27 10:04:16

Kurk Watson
2019-06-27 10:06:21

Dan Smith
2019-06-27 10:12:20

Bob Deblier
2019-06-27 10:13:04

Bob Deblier
2019-06-27 10:14:04

Dan Smith
2019-06-27 10:15:30

John Cook
2019-06-27 10:18:02

Ryan Cook
2019-06-27 10:26:05

Mark Wise
2019-06-27 10:43:53

Mark Wise
2019-06-27 10:44:48

Scott Clark
2019-06-27 11:30:46

Andie Laverne
2019-06-28 03:19:45

原文網址 Kurk Watson
2018-12-13 15:06:56

Hey group.
Been getting some good prints and just about to finish my sample bottle.
Now i have a slicing issue.
I'm using the Stock slicer from Anycubic. Haven't changed anything from last prints, but now when i slice something it gives ridiculous short print times.
Eg. I imported this large solid bit and it says 9m. Which isn't right. It does like one layer and says its finished.
Any thoughts? I've downloaded the latest version too.
Should i try chitubox instead?

翻譯年糕

Marcin Kaleta
2018-12-13 15:15:31

Isaac Doubek
2018-12-13 15:17:58

Kurk Watson
2018-12-13 15:40:40

Kurk Watson
2018-12-13 15:41:49

Chad Elstad
2018-12-13 21:26:05

Mark Wardle
2018-12-14 01:38:18

Mark Wardle
2018-12-14 01:39:33

Mark Wardle
2018-12-14 01:40:28

Kurk Watson
2018-12-14 14:02:36

Cody Raskin
2018-12-15 01:50:48

原文網址 Kurk Watson
2018-11-19 11:00:24

So here is my first print.
I made it small (approx 20mm high).
I tilted it back 45 degrees and did small supports. I noticed that when i removed these that it left little "pock" marks wherever they made contact. Im assuming this can be reduced in making the contact points smaller?

Also, do you think i needed to tilt it 45' or prints with flat bases, i can print them straight off the plate?
Thanks for your help.

翻譯年糕

Mark Wardle
2018-11-19 11:02:47

Stefan Giudici
2018-11-19 11:03:00

Mark Wardle
2018-11-19 11:04:07

Savio Ku
2018-11-19 13:50:24

Ron Mitchell
2018-11-20 02:06:04

原文網址 Kurk Watson
2018-11-15 06:42:45

Printed my first thing since receiving my printer this week.
Tried doing something else apart from the demo torture test but they failed.
User error im assuming.
But super excited it works. ?

So is there a way to determine if it has been printing before it gets higher then the rim of the tank so you can physically see?

翻譯年糕