unpacked my Photon S yesterday. test print ran fine. but today when I try to print my files I keep keeping the "file format error" I have checked my stl. it is a solid piece and is a good mesh. I have supported and sliced... file just wont run and I keep getting the same error message. We did name the file .photons like the book says... any ideas?
翻譯年糕
Alex Vee
2019-04-25 01:36:52
Dan Hjulberg
2019-04-25 01:37:08
Derek Reihe
2019-04-25 01:39:21
Wayne Britt
2019-04-25 01:43:19
John Fulmer
2019-04-25 01:43:53
Zena Andreou
2019-04-25 01:45:15
Wayne Britt
2019-04-25 01:45:53
Justin Auz Williams
2019-04-25 01:47:30
Алексей Устьянцев
2019-04-25 01:48:30
Wayne Britt
2019-04-25 01:51:48
Wayne Britt
2019-04-25 01:52:12
Wayne Britt
2019-04-25 01:54:57
Wayne Britt
2019-04-25 01:57:52
Алексей Устьянцев
2019-04-25 01:59:35
Wayne Britt
2019-04-25 02:08:54
Wayne Britt
2019-04-25 02:09:53
Che Fielding
2019-04-25 02:31:56
Wayne Rogers
2019-04-25 03:14:30
