I’ve researched high and low and I have not found any information any help would be greatly appreciated.
Can the anycubic photon print .2 mm layer height? If so what exposure have you use.
Is it linear between layer and exposure time?
Example
.03 = 6 seconds
.06 = 12 seconds
.12 = 24 seconds
Or do you have to increase exposure because the light has to pass through higher amounts of resin.
Sorry for the long post.
翻譯年糕
Andrew Chan
2019-05-30 05:54:08
Richard Shapiro
2019-05-30 06:22:48
Robert Silvers
2019-05-30 07:14:52
Robert Silvers
2019-05-30 07:15:51
Matthew Anderson
2019-05-30 07:18:26
Mark Wardle
2019-05-30 07:26:01
Todd Jones
2019-05-30 07:26:15
Mark Wardle
2019-05-30 07:28:21
Robert Silvers
2019-05-30 07:28:22
Todd Jones
2019-05-30 07:29:24
Robert Silvers
2019-05-30 07:31:02
Stefan Giudici
2019-05-30 08:53:05
Stefan Giudici
2019-05-30 08:55:50
Kyle Urban
2019-05-30 13:49:44
Robert Silvers
2019-05-31 04:59:19
