Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Wesley Boynton
2019-05-12 12:02:42

So I'd love to install a heater into my printer, but I'd also love to do something drop-in.

Could one of these theoretically be dropped in, maybe one hole drilled for the power cable, and run inside the photon?

翻譯年糕

Sean O'Hayer
2019-05-12 12:06:44

Wesley Boynton
2019-05-12 12:12:37

原文網址 Wesley Boynton
2019-05-04 00:56:26

I'm interested in printing with Ferrolite. The helpful folks at Tethon3D indicated that some of their customers have had success printing on a Photon, but had to upgrade the light source ("projector").

My questions: How do I do that, and what wattage do I need to buy? I haven't found any data on this anywhere, though I did find a 50W upgrade UV panel for the Photon on sale.

翻譯年糕

Michael Van Kesteren
2019-05-04 05:39:51

Milton Maxson
2019-05-04 05:41:53

Vinicius Silva
2019-05-04 06:09:12

Vinicius Silva
2019-05-04 06:10:18

Michael Van Kesteren
2019-05-04 06:12:15

Michael Van Kesteren
2019-05-04 06:14:52

Vinicius Silva
2019-05-04 06:18:20

Michael Van Kesteren
2019-05-04 06:28:12

Stefan Giudici
2019-05-04 06:50:53

Shayne Webb
2019-05-04 07:58:56

Jason Bitter
2019-05-04 08:28:20

Jason Bitter
2019-05-04 08:38:50

Jeremy Lauzon
2019-05-04 14:21:34

Milton Maxson
2019-05-04 20:12:49

Wesley Boynton
2019-05-05 01:04:51

Wesley Boynton
2019-05-05 01:05:43

Wesley Boynton
2019-05-05 01:05:51

Wesley Boynton
2019-05-05 04:30:01

原文網址 Wesley Boynton
2019-05-03 04:06:49

So as I print parts, some of them are detailed little buggers with tiny holes that leave no room for proper sanding...but they clearly need sanding. They're functional parts. They print with the holes and general dimensions slighty too big to fit in place.

My question -- is there an alternative to sanding that will take off a clean layer of the resin and prepare it for curing? Jewelry tumbler? Heat gun? I don't know. Doesn't matter to me if it's very slow and takes forever so long as it's not using microscopic drill bits and files by hand.

Any suggestions?

翻譯年糕

Andrew McKay
2019-05-03 04:20:16

Stefan Giudici
2019-05-03 04:20:31

Andrew McKay
2019-05-03 04:21:17

Wesley Boynton
2019-05-03 04:25:07

Wesley Boynton
2019-05-03 04:25:17

原文網址 Wesley Boynton
2019-05-02 07:02:32

So I've got some resin that hardened overnight and stuck to my build plate. Now I can't get it off. How do I nix it without scratching my build plate? (I think my build plate may have actually arrived with a couple minor scratches.....)

翻譯年糕

Dustin Skye
2019-05-02 07:30:47