Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I picked up some of the SainSmart Rapid UV resin (flesh colored) and I can't find any consensus on what settings to run it at?

Currently I'm using what i do for Anycubic Aqua Blue. We'll see if it fails or not.

翻譯年糕

I have to brag on Phrozen's dark green wax-like castable resin. I used the recommended settings and it came out with no issues whatsoever. I did however pre-cure a thin layer on the bed before i started the print. Just in case.

翻譯年糕

I'm finally making the switch to ChiTuBox and I'm struggling a bit with layer lines. I've printed a pendant with both chitubox and the photon slicer and only the chitubox one has some pretty noticeable layer lines. Printing at 45 deg using the recommended settings for Anycubic Aqua Blue. Any idea what setting needs to be tweaked in Chitubox? Thanks!

翻譯年糕

So I've had my Photon for about 3 months and for the most part my prints are turning out fantastic but there are two very specific issues I am having.

1. Whenever I try and print something directly on the bed it either will stick to the film OR it will suction so hard the bed will get tilted.

2. Whenver I print things like very small jewelry pieces or miniatures the details are always very smoothed over or almost blobby.

I've leveled it many times, made sure the resin was shaken, I'm using the spreadsheed for anycubic green. Most of the time the prints just look fantastic. Any help would be appreciated!

翻譯年糕