Hey guys, I've recently got a Photon and am trying to print some minis, but I don't seem to be able to achieve the same amount of detail I see a lot of people getting - the faces seem kind of melted lol. I angle them back about 30 degrees. I'm using Monocure Rapid Grey, with a bit of Monocure Flex in as well, with settings of Layer: 0.05 and Exposure: 20 secs - do I need to increase these settings more?
翻譯年糕
Sophie Odette
2019-08-11 09:46:37
Jean-François Meloche
2019-08-11 09:49:08
Kyle Calderwood
2019-08-11 09:49:53
Andrew Wez Westwood
2019-08-11 09:55:48
Chad Elstad
2019-08-11 09:57:58
Matt Mason
2019-08-11 10:12:19
Scott Clark
2019-08-11 10:19:26
Stefan Giudici
2019-08-11 10:22:07
Chad Elstad
2019-08-11 10:22:43
Chad Elstad
2019-08-11 10:25:47
Andrew Wez Westwood
2019-08-11 10:30:58
Seona van der Pol
2019-08-11 10:36:07
Franz Meriles
2019-08-11 10:44:48
Fred Breton
2019-08-11 10:58:01
Robert Mun
2019-08-11 11:21:06
Scott Clark
2019-08-11 12:15:12
Robert James
2019-08-11 12:44:00
Jeremy Lauzon
2019-08-11 13:02:21
Jason Glavich
2019-08-11 14:16:20
Jason Glavich
2019-08-11 14:17:39
Jason Glavich
2019-08-11 14:19:28
Johan Oettinger
2019-08-11 14:22:09
Andrew Wez Westwood
2019-08-11 15:04:39
Luke Mason
2019-08-11 15:07:20
Luke Mason
2019-08-11 15:08:21
Derek Reihe
2019-08-11 20:41:53
Chad Elstad
2019-08-11 21:02:35
Jason Glavich
2019-08-12 15:10:38
Mendrak Bräm
2019-08-13 14:29:18
