Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Nathan Von Sullivan
2019-09-23 04:19:03

Can anyone give me tips for printing multiple minis at the same time? I've gotten two failures like this so far for things that I believe are otherwise well-supported. I know it has something to do with where on the FEP the suction is the strongest, but I don't know where to go from here and haven't found much on Google. Thanks!

Edit: I know it's leveled, and this failure only happens when I try to print multiple minis at a time. I don't have a problem doing one at a time, anywhere on the plate.

翻譯年糕

Mourni Tenchou
2019-09-23 04:20:30

Nathan Von Sullivan
2019-09-23 04:24:07

Santiago Cardona
2019-09-23 04:31:02

Eric Saffron
2019-09-23 04:38:58

Nathan Von Sullivan
2019-09-23 04:46:05

Jonathan Alvarado
2019-09-23 08:56:25

Nathan Von Sullivan
2019-09-23 09:04:30

Jonathan Alvarado
2019-09-23 09:05:55

Niall Forrester
2019-09-23 21:25:36

Nathan Von Sullivan
2019-09-23 21:34:24

Niall Forrester
2019-09-23 22:02:08

原文網址 Nathan Von Sullivan
2019-09-05 15:24:07

Something that is probably common sense but easy to miss, and which I don't think I've seen come up yet here (although I just joined and got my Photon two days ago) - the importance of being sure the surface the printer is itself sitting on is level. I failed two test prints before noticing each time that the base had somehow fallen to the far left side of the vat both times instead of merely dropping below to the center. Eyeing the resin against the vat's bevel line and a bullseye level, I found out that my table was buckled in the middle just enough to skew the print even if the bed was technically level otherwise. I put a nickel under each of the left feet and now my test print is humming along at 70% without a hitch. Victory!

翻譯年糕