Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Alright. Been a while since I needed help. Struggling with this simple print and I’ve tried just about everything. (Photo in the comments)

- Printing with standard Anycubic Translucent Green with 8sec exposure on 0.05mm layers with 6 bottom layers exposing 60sec each
- Verified that I am able to print other (much more complex) files just fine
- verified that others have had no trouble with this print ( https://www.thingiverse.com/thing:3453131 )
- the print appears to go alright until the last several layers
- It is at least consistent and I get the same result every time
- Tried with and without supports
- Powered the machine off and on
- Re-leveled
- Verified slice file validity and even watched the printer print the last several layers.

Any advice is greatly appreciated as I thought this would be a quick no-stress print. I guess that’s what I get haha.

翻譯年糕

Newb question: Sometimes I notice that flat prints (like dungeon tiles) slip around and distort when I try to print them to the base. I don't have any issues when I use rafts/supports but I'd like to be efficient with my time and resin if possible. Is there something I can do that would allow me to print these kinds of things straight to the build plate?

翻譯年糕

I printed my first prints with Elegoo Grey resin and followed the settings in the lofty spreadsheet of resin goodness. It calls for 100s for 8 base layers and then 18s for every layer after. The prints I got out looked okay but feel a bit "soft" or "gummy". Leaving them in the sun for a couple days has given me little to no improvement. My guess is that the normal layer exposure is too long and I'm getting some light bleeding but thought I'd ask in here. Anyone else using Elegoo Grey with these or different settings?

翻譯年糕