Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Tim Hope
2019-12-01 17:18:01

Hey guys, I’m trying to pull some silicone casts of models I’ve printed. I’ve found the silicone won’t cure while in contact with the resin. Has anyone else run into this?

I’m using any cubic grey.

I’m going to give it another shot with some parafin mould release as a barrier. But thought I’d post here for tips before wasting another round of silicone.

翻譯年糕

Rose Stumpwater
2019-12-01 17:27:10

Richard Humble
2019-12-01 18:02:40

Tim Hope
2019-12-01 18:32:44

Chris Carter
2019-12-01 19:37:46

Dan Barca
2019-12-01 22:25:28

Dan Barca
2019-12-01 22:27:46

Maggie Jenner-Bennett
2019-12-01 23:49:46

Joe Broggio
2019-12-02 00:14:28

Chayanin Somton
2019-12-02 01:30:52

Joseph Armes
2019-12-02 02:00:43

Consuelo Gonzalez Fuentealba
2019-12-02 02:24:18

Samson Chen
2019-12-02 05:14:20

Ali Aliraqi
2019-12-21 20:17:47

Ali Aliraqi
2019-12-21 20:19:07

原文網址 Tim Hope
2019-11-18 20:17:53

First print a success. Wildly underestimated the size these would turn out, but I guess now I’ve got some teeny tiny dice blanks. Anyone got any tips for get accurate sizes in STLs and the slicer? These came from blender because I’m going to do some procedural modelling in future iterations. They were all accurate dimensions in blender but turned out even tinier than this (like smaller than a cm for the whole thing) when I imported the STL into Chitubox.

I’m guessing the issue is a Blender metre not actually being a metre. If anyone has any experience there let me know!

翻譯年糕