Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Pete Bellamy
2019-11-24 03:34:24

Total noob here. Just got my first printer, the Photon. They were out of the translucent green and didn't send any resin, but will send it when it's back in stock. So I went on Amazon and bought the cheapest Anycubic resin. Not sure why different colors are different prices, but it was 500ml of maroon.

I'm guessing this is the culprit for my constant failed prints, as I consistently get up to about 1 mm of the foundation of the print stuck on the FEP. I've tried every leveling method I can find, have tuned the FEP to 330 Hz, shaken the resin, tried the exposure finder by x3msnake, done a few dances, prayers, and sacrifices. No dice.

When you press Home in the z-move section, is it supposed to go down, beep twice, come back up a few mm, then go back down to home? I've wiggled paper under while doing this, as it acts like it's sensing too much pressure (like a garage door), but it doesn't pinch the paper. It does this every time when going home, or beginning a print. Not sure if it's relevant at all. especially as the first number of layers does seem to print fine.

翻譯年糕

Darren Wade
2019-11-24 03:36:29