Have a little issue but it is only with Elegoo Black. I don't get this line with my Transparent Red or White. Yes I know my supports are over kill but I have been try to prevent this shift. FEP rings 305. Flint Reid leveled. All screws are tight. Temp inside is 26c. Bottom layers is 6@100 sec. This one the layers were at 8 previous ones were 12 & 14 which the line was way more pronounced. Any ideas where I should go next?
翻譯年糕
Stefan Giudici
2019-12-30 21:00:33
Joseph Gasser
2019-12-30 21:18:13
Joseph Gasser
2019-12-30 21:22:08
Chris Bondy
2019-12-30 21:27:16
Joseph Gasser
2019-12-30 22:29:18
Joseph Gasser
2019-12-30 22:30:03
Joseph Gasser
2019-12-30 22:31:28
Chris Bondy
2019-12-30 22:35:09
Joseph Gasser
2019-12-30 22:52:41
Joseph Gasser
2019-12-30 22:53:58
Joseph Gasser
2019-12-30 22:54:24
Chris Bondy
2019-12-30 23:00:02
Chris Bondy
2019-12-30 23:07:40
Joseph Gasser
2019-12-30 23:10:39
Chris Bondy
2019-12-30 23:14:26
Chris Bondy
2019-12-30 23:26:32
Joseph Gasser
2019-12-30 23:26:43
Chris Bondy
2019-12-30 23:29:03
Joseph Gasser
2019-12-30 23:32:55
Chris Bondy
2019-12-30 23:56:59
Chris Bondy
2019-12-31 00:05:10
Chris Bondy
2019-12-31 00:12:04
Chris Bondy
2019-12-31 00:16:15
Joseph Gasser
2019-12-31 20:29:53
Joseph Gasser
2019-12-31 20:30:18
Joseph Gasser
2019-12-31 20:30:40
Joseph Gasser
2019-12-31 20:31:39
Chris Bondy
2019-12-31 20:36:08
Joseph Gasser
2019-12-31 20:45:53
Chris Bondy
2019-12-31 20:46:57
Joseph Gasser
2019-12-31 20:49:56
