Hi im a new photon s owner. Ive been printing for years with fdm printers but this is my first sla printer. Ive been trying for days to amke a sucessfull print with no luck. The best i can get is a small layer fused to the bottom of the vat nothing sticks to the build plate. i have tried adjusting the exposure. I leveled and releveled the bed. I changed the plastic at the bottom of the vat because some have said that the plastic that comes preinstalled can cause issues. I even removed the built plate and the vat and fired up a print to see if the dlp is lighting up and it is though it dosnt seem to bright. im not sure how bright it should be. my last attempt was to try the flint read method of leveling and im noticing when i have the vat installed and i try and bring the bed down just till the wobble in the plate is goes with the set screw loose it reaches the bottom possible z and starts to grind and the build plate still had room to wobble. do you guys have anymore suggestions or is it time to rma the printer?
翻譯年糕
Victoria L. Cordone
2020-01-19 00:40:42
Chris Giesen
2020-01-19 00:43:54
Sean Guna
2020-01-19 00:48:47
Chris Giesen
2020-01-19 00:49:56
Sean Guna
2020-01-19 00:51:44
Brian Romine
2020-01-19 00:52:40
Sean Guna
2020-01-19 00:53:49
Chris Giesen
2020-01-19 00:54:02
Sean Guna
2020-01-19 00:54:36
Sean Guna
2020-01-19 00:56:14
Jeff Greenfield
2020-01-19 00:56:26
Chris Giesen
2020-01-19 00:56:30
Sean Guna
2020-01-19 00:57:07
Chris Giesen
2020-01-19 00:57:45
Jeff Greenfield
2020-01-19 00:59:17
Chris Giesen
2020-01-19 01:04:41
Sean Guna
2020-01-19 01:10:43
Haydn Nelms
2020-01-19 02:28:08
Luca Cavallari
2020-01-19 02:58:34
Luca Cavallari
2020-01-19 03:02:46
Niall Forrester
2020-01-19 09:13:24
Jose Sicairos
2020-01-19 15:00:44
Chris Giesen
2020-01-19 21:54:29
Chris Giesen
2020-01-21 19:25:46
