Anycubic Photon Printer Owners 造訪社團

Follow on from yesterday's post.

Hey I'm having an issue where my fep and screen are sticking together (like a glass protector of a phone) this "I think" seems to cause light to bleed though and cure a thin layer in the bottom of the vat, prints come out fine but I have to clean the vat out every time.

Just to make sure everyone knows I did remove both sides of the protective film, it's the spare one that comes with the machine and i have cleaned the fep and glass with ipa at least 4 times now and let it dry before sliding the vat in.

Might try a new fep but before i do does anyone have any idea? Thanks.

翻譯年糕

Yrel from World of Warcraft. Custom sculpt done by Nickey Dimchev for me. Printed at 0.05mm with Monocure Rapid grey.

翻譯年糕

Welp. Let my example be warning to others. I just printed quite a big part of my model three times and by my own stupidity ruined the first two. First I was curious how’s the print doing and paused the print. But the pause button didn’t seem to react so I pressed it, like the idiot I am, several times. It did stop the print. But also confused the printer, so after I resumed the print, it started “printing” in the air, hanging several centimetres above the vat. Oh well. I removed the 2/3 finished print, found few supports that were too close to the object and fused with it. Oh well, at least I could fix that. I moved supports, sliced in ChituBox, checked layers, exported and let print overnight. In the morning I found the “finished” print, missing almost exactly the same bit like the one I interrupted. I found out that if you export sliced object from ChituBox while checking your layers, the print stops at the layer you were checking! Oh well, resliced, reexported and third time was the charm.
So in conclusion, don’t press the pause button ten times in a row and always finish the layer check.

翻譯年糕

https://youtu.be/BzG6j1v9hSU

Since I installed the new screen, I've been getting this odd pattern and exaggerated layer lines at the same settings I used previously for flawless prints.

Any ideas?

翻譯年糕

Hi. Yesterday I did a large print, towards the end of the print there was a split in the print. Fairly large as you can see, I tried re-opening the file in the photon file checker but it wouldn’t load so I put it down to a corrupt file.

Re-sliced the file and put it through the proton checker this time and re-printed and it’s done the same again however luckily this time it’s salvageable.

Any ideas?

翻譯年糕

Finally my first acceptable print! 1 cleaned with alcohol, the other one just water.

翻譯年糕

My apologies if this has been asked before. Will this fit the original Photon? I'm thinking for the price I'll get one in for spares.

翻譯年糕