Anycubic Photon Printer Owners 造訪社團

Well this is my 8th resin calibration, I've relevelled the bed several times and this is the best i get.

翻譯年糕

Really disappointed with AnyCubic. Not really anything to do with "support", but I was trying to purchase a couple of the nice buildplate securing knobs, you know, the nice RED ones that secure the buildplate to the gantry? It seems they work better than my other buildplate knobs on my other printer, and they have both crumbled (they were plastic knobs glued to a bolt!). Anyway, it seems they don't sell them separately, so they tell me to order a $30 package of bolts on Amazon, give them the order number, and they would send me ONE knob! Seriously? ONE knob would cost $30? So sad...

翻譯年糕

Which is the best spray primer i can find on the internet?

翻譯年糕

Ok, it's time to ask for recommendations after 12 consecutive failed prints. I leveled the bed at least 7 times, trying from very tight on a single layer of paper to barely touching the paper folded over five times. The base attaches to the build plate, but my supports don't print or I only get stumps of supports. There is always material stuck to the plastic sheet in the vat. I've replaced the sheet, tried new resin (yes, I shook it up well), and I'm not printing anything that is overly difficult. The test print cube doesn't even print. I've tried sanding the print bed slightly in an 'X' pattern. Most prints were attempted with AnyCubic gray, 16s cure time, 1.5-3s off, 8 base layers at 70s. These settings worked before.

翻譯年糕

I've ordered the clear resin from anycubic.com and this is what i've received... I've ordered the clear resin from anycubic.com and this is what i've received... 翻譯年糕

It may be a little hard to see in these photos but there is a line in the print (my third print). I believe that is where I paused and restarted the print. That's normal, correct? Also, every time the print lifts for the next layer, there is a small clicking sound as if the layer is sticking to the print basin. Normal as well?

翻譯年糕

Does anyone do print commissions? I have a bunch of minis (Stouthearted Heroes by Rocket Pig Games) and I'm looking to get them printed and shipped in the U.S. for hopefully a reasonable price. ?

翻譯年糕

hello guys can you tell me where to find photon print settings? I have to print characters thanks

翻譯年糕

thank you guys for helping me with your settings, still not perfect prints but that's because I'm being cheap with supports. this printer is awesome!

翻譯年糕

Hi everyone. Im new to this type of printing. Im after buying one but am getting confused. On ebay they adverdise it as a dlp printer. Some say sla/dlp. Can anyone please put me on the right track. Thought sla was lazer and dlp was uv projected. Thank you

翻譯年糕