ATOM 3D Printer Group 造訪社團

求救!!ATOM2.0冷卻風扇不會轉!!!
小弟完全不曉得為什麼才剛要開始印一個新物件，風扇就好像有點接觸不良，動一下停一下，然後就完全不動了!請各位大大救救小弟我!拜託!

Hi!

嗨!

· 查看原文 · 為此翻譯評分

進料順了，杯麵就來了。「你好～我是杯麵」

利用123D Design及手邊庫存608軸承搞了一個進料的導輪跟支架，分享給大家我的小小想法

飛龍駕到，有些地方細節我處理得不好，鬆緊帶的綁法還不是很熟練，所以很多姿勢矲不出來，大家看看就好

請問各位大大是否有遇過3D建模轉stl檔後，模型多出一塊物件？？

Here are photos of how I resolved the problem of the Z-Min adjusting screw hitting parts of the printed model:

The first photo shows how my extruder end looks now. I think you can see that the adjusting screw is a few mm above the level of the nozzle end.

Photo #2 shows what I cut off from the adjusting screw. During reassembly I realized it was better to remove the washer at the top end of the adjusting spring, so that is the washer in the photo.

Photo #3 is the tool I used to cut off the end of the screw. It is a clone of the standard Dremel tool with the default cutter disk on the end.

I'll be happy to provide detailed instructions for how to do this for anyone who is interested. The whole procedure took about 30 minutes.

翻譯年糕

我這台ATOM2.0是請廠商組裝的，想問一下我這台的風扇是原廠的嗎？因為今天廠商打電話過來問我風扇的長寬，我感到疑惑，po來問一下各位買家

An interesting problem: Here are 2 pics from an aborted attempt to print the Eiffel Tower model. I scaled the model up to 270mm height and used a layer height of 0.200 mm. As you can see I used no support structure which may have been my fatal mistake.

The first photo shows the results after about 5 1/2 hours of printing. The second shows a close-up of the results about an hour later. I had to stop the print because the Z-Min adjusting screw got caught in some un-evenness and knocked off a couple of pieces of the tower's support beams. When this happened 2 of the magnetic arms came off their knobs and I of course had to stop the print. Fortunately I was close by when this happened; I had planned to let the print continue all night. I'm not sure would have happened if I had not been there to stop the printer.

I don't know if I am the only one who has encountered this problem, but it could be easily fixed by simply using a shorter screw for the adjuster. It wouldn't have to be much shorter - just a few mm would have prevented this problem from happening.

翻譯年糕

新上市PLA膠條1.75mm(一捲500g)
3 D列印實在有夠夯
生活應用便民很平常
膠條材質繁雜無法擋
新品上市眾人搶先嘗
耐熱仿木咖啡處留香
來自台灣在地的工廠
感謝指教分享不私藏
留下聯絡資料好商量
聯絡人、地址、電話、
預購Email To：
dualrock@dualrock.com.tw