Hello there!
:)
I have a question to all of our Atom 2.0 users out there.
When pre-heating your printer, doesn't matter if directly printing or using prepare => Preheat 200°, does your hotend start to ooze as well? Around 140~160° my printer starts to make a spaghetti of my filament although the extruder-motor doesn't push filament through.
Wouldn't budge me if it wasn't for the fact that the printer drops that spaghetti on the plate and rubs and scratches above it while printing first layer.
When I wipe it away, it keeps dripping on, after 2 minutes it stops. But if I start printing then, it needs more than 6 brim layers to start printing.
And of course if I stop wiping it away when he goes down to start a print, he spreads the blob on the plate, resulting in scratching the thing or even the whole brim away.
:(
Does anyone of you have the same issue? Or is it just me? Always wiping away gets a little bit on my nerves.
Another issue: This morning I started a larger print which was around 15 x 18 cm on plate.
The longer one was on the Y axis.
I had the printer do the auto-level when I turned it on and adjusted my Z offset because I made new kapton tape on the plate.
The printer made the middle part, Left and right on X axis and started the front part on Y axis. No probs so far. But when he went to the back on the Y axis (so in front of the tower on the opposite site of the printer) he scratched my Kapton away
:(
Any ideas on that one? Happened two times, stopped the print, did auto level again etc, same prob.
Thanks in advance guys ^^
翻譯年糕
黃俊傑
2015-12-01 20:31:05
for first problem. it's normally.just like asshole if without the muscle all shit will coming out... so that's why when u preheat.
Joschka Friedl
2015-12-01 20:32:35
Okay.. Other guys i know having a 3D printer told me theirs don't ooze. But nice comparison
?
黃俊傑
2015-12-01 21:50:16
Joschka Friedl
2015-12-01 22:53:40
Had that problem last time. It ripped my prints off because of curling. Reducing print speed to 75% solved that one. Z-Hop is fine on my printer.
All in all it seems that something with the delta-geometry or the auto leveling goes wrong, because in the Middle, X Axis (Left-Right) and in the Front Y Axis, it prints fine and clean. Only on Y Axis Back (Front of C/Z Tower) he scratches the Tape and the Print bed.
:/
Marge de Manoeuvre
2015-12-03 11:35:34
same problem as you in fact, when printing near the z axis column (the one with the step motor for the filament ) something is wrong and the head scratch my bed too, what could we do ?
