Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 John Bussell
2020-02-16 21:34:44

I’ve been having a lot of trouble with excess resin on my prints, and I’m not sure what it is I’m doing wrong.
Whichever side of the model is facing the build plate ends up covered in extra cured resin by the time the print is finished, which deforms the surface and affects details. Does anyone know why this is happening and what I can do about it?

I’m using the original Photon with Monocure Rapid Grey resin, which I pre-warm and shake. My printer is in a warm room (it’s summer here in Australia) and I cover the printer windows to make sure no sunlight leaks in if I’m printing during the day.
I’ve attached my printing settings, which I got from the Monocure website.

翻譯年糕

Sargent Raze
2020-02-16 21:44:42

Allison Janssens
2020-02-16 21:44:44

John Bussell
2020-02-16 21:45:17

John Bussell
2020-02-16 21:46:04

Sargent Raze
2020-02-16 21:47:53

Richard Humble
2020-02-16 21:49:08

Allison Janssens
2020-02-16 21:50:00

Nipuna Gunarathne
2020-02-16 21:50:30

John Bussell
2020-02-16 21:51:19

John Bussell
2020-02-16 21:51:51

Nipuna Gunarathne
2020-02-16 21:53:05

John Bussell
2020-02-16 21:59:55

原文網址 John Bussell
2019-08-09 15:05:26

I’m at a loss here. When printing the cube that comes with the printer, it starts off fine, but around 30-40% the print starts “flexing” as it moves after each layer and it’s all downhill from there.

Is it a bed levelling issue? I’ve tried both the method in the manual and the Flint Read method and they’ve both turned out as bad as each other. I’m printing with Anycubic green.

I wanna move onto other prints, but I’m worried that this issue will carry over :/