Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I just finished my first miniature painting - three little owls. I also tried to respect printing tips. The model was rotated at 10 degrees and support was placed manually. As you can see, in manual mode I needed less support but the print still worked very well. Printed 3 owls at once with transparent green resin at 0.02mm with 7.5s exposure time. The model was scaled to 32x31x34 mm. Removing the 3mm height support was easy. I used hot water to remove the support before curing, which also helped a little bit.

I bought brushes with the sizes "2" and "1" and a "Base paint set" from citadel. As preparation, I covered the owls with "Corax White" spray. I wanted to paint bright and saturated base colours. But unfortunately, I found out that the colours are all darkened mixtures. For example, Yellow is named "Averland Sunset" and isn't at bright as you would paint a sun-flower or a rubber duck. So I had to mix them up. I added white to make them brighter and used a baking paper on a wet paper towel to mix the colours. The first attempt on my kindergarten level colour understanding... the colours get much brighter than expected. So I used less white. But after painting and drying, I saw that the colour became darker - lesson learned.

So I started painting... A bit trick is to prepare the right amount of mixed colour. If you need more, it's catchy to find the correct mixture for the same colour again. I sealed them with "Aegis suit", a glossy varnish. Used about 2 short colour waves from four angles and top. Now the should be bulletproof and immortal and look shinier. I even expected to get a complete polished surface, but the surface is still rough, which is also very nice.

I Never expected to need so much time. It took me 8h to paint the three owls. But hey... now I'm very proud my three sweeties and happy to try it out ? I also got much more respect for bigger paintings. I will concentrate on smaller parts.

Model:
https://www.myminifactory.com/ob…/3d-print-winter-owl-106973

翻譯年糕

Supports needed? Just printed the Vampirella model on the Photon S . Needed more than 90min to cut off all supports. Was very hard to reach all with the knife or scalpel. Printed it laying with a height of 75mm, so I needed only support on her backside. What do you think, should I use less support and even place it manual, for my next print? Tried it with sandpaper, but her back still looks very scruffy. Sliced in CHITUBOX, printed at 0.02mm with 8s exposure time. The exposure time for the Resin was also a guess -but it has good details.
I will try a paint, as soon I feel prepared ?
Model: https://www.thingiverse.com/thing:3657993 翻譯年糕