For new owners!!! If your builds are failing to adhere to the build plate, this is the fix that 100% solves the issue and it can be printed on your Photon for your Photon. The issue is caused by a defect in the design where the control arm comes in contact with the resin tray wall, leaving a gap of only 0.02mm. This might not seem like an issue at first but when your initial layer is typically 0.03mm thick it tends to stick to whichever object holds the majority of its mass.
This is super easy to install once printed and due to its small size comes off the printer almost completely cured. Remove the 4 screws holding your build plate and insert this between the build plate and mounting bracket. Replace the screws, re-level, and your builds should no longer stick to the tray.
Happy Making!
翻譯年糕
Jens Verwaest
2020-02-01 18:35:32
Andrew Short
2020-02-01 18:37:09
Niall Forrester
2020-02-01 19:03:57
Andrew Short
2020-02-01 19:06:21
Andrew Short
2020-02-01 19:11:56
Niall Forrester
2020-02-01 19:12:01
Niall Forrester
2020-02-01 19:13:22
Andrew Short
2020-02-01 19:17:21
Niall Forrester
2020-02-01 19:24:13
James Forder
2020-02-01 19:33:31
Andrew Short
2020-02-01 19:39:00
Nemo Vilpponen
2020-02-01 19:43:12
Cristian Cozma
2020-02-01 19:43:37
Dimas Putro Arnindyo
2020-02-01 20:01:14
Niall Forrester
2020-02-01 20:19:13
Dimas Putro Arnindyo
2020-02-01 20:20:05
Chakrapani Nannapaneni
2020-02-01 21:20:00
Joel Mendoza
2020-02-01 22:04:39
Jim Stephens
2020-02-01 22:52:43
Tim Moulton
2020-02-01 23:53:40
Tim Moulton
2020-02-01 23:54:36
Joel Mendoza
2020-02-01 23:56:42
Cameron Lee Johnson
2020-02-02 00:13:29
Keith Yinger
2020-02-02 00:53:50
Keith Yinger
2020-02-02 01:01:33
Tony Nungaray
2020-02-02 02:06:10
James Forder
2020-02-02 03:44:26
Keith Yinger
2020-02-02 03:56:48
Andrew Short
2020-02-02 10:47:08
Tim Moulton
2020-02-02 10:53:49
Andrew Short
2020-02-02 11:14:19
Andrew Short
2020-02-02 11:17:56
Andrew Short
2020-02-02 11:19:06
Andrew Short
2020-02-02 11:20:41
Toby Kirkby
2020-02-02 11:45:06
Toby Kirkby
2020-02-02 11:45:28
Dave Fletcher
2020-02-03 00:32:11
Andrew Short
2020-02-03 11:20:19
Andrew Short
2020-02-03 11:21:11
