Anycubic Photon Printer Owners 造訪社團

原文網址 Michael McSpadden
2020-03-01 02:35:22

So have a strange issue, first time have not seen it before. I haven't printed this sliced file yet but as it was large and would take a while to print. I went through it to see if there were any glaring issues. I see throughout the slice there are jagged artifacts both possitve and negative spaces. what do you guys make of it? the pic is of the bottom layer

翻譯年糕

Rebekah Anderson
2020-03-01 02:41:56

Michael McSpadden
2020-03-01 02:43:46

Rebekah Anderson
2020-03-01 02:47:01

Rebekah Anderson
2020-03-01 02:49:16

Michael McSpadden
2020-03-01 02:57:37

Quol-Amin Impcasor
2020-03-01 03:01:30

Michael McSpadden
2020-03-01 04:13:06

Tom Sargison
2020-03-01 05:48:52

Michael McSpadden
2020-03-01 06:27:12

Tom Sargison
2020-03-01 07:29:40

Rick Hanson
2020-03-01 08:18:37

原文網址 Ryan Drage
2020-03-01 02:05:13

What do you use to cut up STL's into smaller parts for bigger prints?

翻譯年糕

Sebastian Schramm
2020-03-01 02:08:30

Ben Johnston
2020-03-01 02:09:32

Ken Schmitt
2020-03-01 02:12:06

Dan Blea
2020-03-01 02:13:41

Steven Pfaff
2020-03-01 02:26:09

John Henry
2020-03-01 03:19:11

Sebastian Schramm
2020-03-01 03:20:13

Merv Hinton
2020-03-01 03:59:00

Daniel Kottmair
2020-03-01 04:29:33

Chad Elstad
2020-03-01 09:50:25

Chris Wolfe
2020-03-01 10:19:29

John Chrapkowski
2020-03-01 14:46:58

Bruce Moran
2020-03-01 16:15:52

Fernando Cay Diarte
2020-03-03 04:36:39

原文網址 Paul McKee
2020-03-01 01:46:17

First 3d print I've painted to this stage. What would make him look better apart from finishing his knife?

翻譯年糕

Eric Causeway
2020-03-01 01:53:34

Eric Causeway
2020-03-01 01:54:04

Zeb Christmas
2020-03-01 06:41:29

原文網址 Russ Charles
2020-03-01 00:53:21

Looking for any advice... After several months of successful printing, today my print plate went down into the vat and stopped... It doesn't seem to work at all now. None of the inputs work. I've turned it off now, but am open to any thoughts

翻譯年糕