Photon Resin Calibration 1.2
(Link:
https://github.com/altLab/photon-resin-calibration
)
I looked over the files. There is a "test-mode.gcode" - file which executes gcodes on the Photon. After the test, the user has to execute "print-mode.gcode" on the Photon, to remain to normal printing condition.
Here is what I do not understand:
In "print-mode.gcode" are the following lines:
### ### ###
;(Acceleration)
M8008 I700
; The higher the acceleration the faster the overall print time. Too high risks losing steps.
### ### ###
Command "M8008" is setting parameter "I700".
And here it is: Some Photon firmwares includes such parameters files to set standard parameters on Photon after firmware update.
All firmwares i could see, uses the parameter "I900" for the "M8008" command. That is so in firmware 4.2.5 and in firmware 4.2.12 too.
So why does the "Photon Resin Calibration"-Utility sets this command back to "I700" instead of to "I900".
Do I see it right, that the "print-mode.gcode" should / could be changed, so that to command "M8008" parameter "I900" is set?
What is your opinion to this matter,
Vinicius Silva
?
I would like to use the "Photon Resin Calibration" Utility and not knowing about changing the "print-mode.gcode" or not?
Thank you for your answer.
Artur
翻譯年糕
Vinicius Silva
2019-05-14 10:11:42
Vinicius Silva
2019-05-14 10:11:45
Artur Kawa
2019-05-14 10:14:07
Vinicius Silva
2019-05-14 10:15:03
Artur Kawa
2019-05-14 10:15:18
Vinicius Silva
2019-05-14 10:16:10
Artur Kawa
2019-05-14 10:18:35
Artur Kawa
2019-05-14 10:24:43
Vinicius Silva
2019-05-14 10:24:44
Artur Kawa
2019-05-14 10:25:57
Vinicius Silva
2019-05-14 11:01:47
Vinicius Silva
2019-05-14 20:16:22
Artur Kawa
2019-05-14 22:13:12
Vinicius Silva
2019-05-14 22:16:31
Vinicius Silva
2019-05-14 22:17:02
Artur Kawa
2019-05-15 01:06:12
Raphaël Gerber
2019-05-15 15:37:48
