Quick question: I just got a photon and I’m in the middle of my first print. Is it a problem for the build plate to be crooked during printing? I leveled it according to the instructions and got the screw as tight as I could. I can’t tell if the print is going to fail at this point because it’s only about 2 hours in, but I was hoping someone with more experience can let me know if this is ok. If it’s not ok - what do you think I did wrong?
Update: I had added an additional bolt to the build plate. I went ahead and took apart the build plate, cleaned it, and made sure all the bolts were tightened. I then re-leveled it, making sure that after tightening there was zero movement of the plate. I then restarted the print. I will not have a chance to check the results until tomorrow, but I will update again when I get a chance. Thanks to everyone who commended.
翻譯年糕
Josh Norris
2018-12-24 05:11:31
Stefan Giudici
2018-12-24 05:11:55
Rahul Anand
2018-12-24 05:12:42
Matt Tilson
2018-12-24 05:12:47
Ben Tseng
2018-12-24 05:18:00
Brandon Blewett
2018-12-24 05:22:22
Sean Latto
2018-12-24 05:22:24
Stefan Giudici
2018-12-24 05:22:50
Stefan Giudici
2018-12-24 05:23:31
Gustaf Sjögren
2018-12-24 05:48:20
Stefan Giudici
2018-12-24 06:38:58
Dana McDonald
2018-12-24 07:11:08
Jason Odegard
2018-12-24 07:43:21
Ben Jackson
2018-12-24 08:20:53
Matt Moffatt
2018-12-24 10:44:05
Matt Moffatt
2018-12-24 10:44:22
Nick Santana
2018-12-24 13:21:48
Daniel Lawrence
2018-12-24 14:42:41
Cody Raskin
2018-12-24 15:01:27
Joan BG
2018-12-24 15:27:48
Bernard Vanosmael
2018-12-24 17:45:33
Bernard Vanosmael
2018-12-24 17:46:10
Stefan Giudici
2018-12-24 17:48:12
Stefan Giudici
2018-12-24 18:13:17
Bernard Vanosmael
2018-12-24 18:25:40
Bernard Vanosmael
2018-12-24 18:25:44
Bernard Vanosmael
2018-12-24 18:25:48
Andreas Maurer
2018-12-24 21:17:21
Stefan Giudici
2018-12-24 22:33:19
Rusty Welsch
2018-12-25 02:14:45
Carlos Roberto
2018-12-26 02:57:31
David Duc
2018-12-26 04:40:34
Brandon Blewett
2018-12-28 13:36:18
