So, I see a lot of you talking about using ultrasonic cleaners with IPA to clean your models after printing. Is that not incredibly dangerous? IPA has a very low flash point and is inherently unstable (it is a solvent after all). Combine that with ultrasonic waves which will heat the solvent up over time, it sounds like a very bad idea. Yet everyone seems to be doing it.
Does anyone have any thoughts or opinions on this?
翻譯年糕
James Hendrix
2019-10-13 22:20:47
Chris Baker
2019-10-13 22:22:04
Simon Wilson
2019-10-13 22:23:28
John Fitzgerald
2019-10-13 22:25:53
Matt Olsen
2019-10-13 22:27:04
Joshua Cockburn
2019-10-13 22:29:13
Nigel Davies
2019-10-13 22:31:16
Mark Wise
2019-10-13 22:35:58
Wayne Rogers
2019-10-13 22:36:37
Chris Baker
2019-10-13 22:39:50
Dan Andersson
2019-10-13 22:47:28
Mike Armijo
2019-10-13 22:48:03
Chris Baker
2019-10-13 22:51:18
Keith Barnett
2019-10-13 22:58:37
Michael S Dooley
2019-10-13 23:08:43
Matt Olsen
2019-10-13 23:13:52
Matt Olsen
2019-10-13 23:14:59
Chris Baker
2019-10-13 23:23:18
Erik Cederberg
2019-10-13 23:31:58
Matt Olsen
2019-10-13 23:34:42
Keith Barnett
2019-10-13 23:44:00
Erik Cederberg
2019-10-13 23:45:22
Matt Olsen
2019-10-13 23:57:19
Jez Clark
2019-10-14 00:20:05
Chris Baker
2019-10-14 00:24:55
James Hendrix
2019-10-14 01:22:03
Matt Olsen
2019-10-14 01:24:13
Sercan Güzel
2019-10-14 10:08:51
Erik Cederberg
2019-10-14 10:26:04
Allan Johansen
2019-10-14 14:54:45
Chris Baker
2019-10-14 15:33:14
Robert Mako Sharkey
2019-10-14 16:45:40
