Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Ken Foote
2019-11-24 01:43:45

Does anyone know if Anycubic support replies to emails on the weekends, waiting to hear back from them, just wondering. Thanks

翻譯年糕

Joe Comedian
2019-11-24 01:48:54

Dan Andersson
2019-11-24 01:49:46

Tomasz Biłas
2019-11-24 01:50:52

Jeff Greenfield
2019-11-24 02:25:34

原文網址 Ken Foote
2019-11-22 02:29:24

Well I've had my printer for a grand total of 2 days with ZERO successful prints and now the Z-axis has stopped moving. See the video I have attached to hear the deep humming noise when the z-axis is trying to move. I have read a tonne of comments on this page. The following are the things I have already tried: Open a ticket with Anycubic support, lol Updated firmware from 4.2.17 to 4.2.18 Ran Factory Defaults GCode (in case of EEPROM problems) Disassembled the printer to make sure no loose connections on motherboard Does anyone have any other helpful advice I can try. Was really looking forward to being an active part of this group but am now wishing I never bought this printer at all.
Thanks in advance. 翻譯年糕