Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Kathy Ogilby Langdon
2020-03-26 22:53:30

What could cause consistent holes in minis? Seems as if the holes occur at the same place on build plate.

翻譯年糕

Jure Slokar
2020-03-26 22:56:23

dead pixels usually

Cannon Rigger
2020-03-26 22:56:55

If it's consistent, there may be an island.
Or try repositioning it on the plate and reslice to see if it's your LCD.

Christopher Fugate
2020-03-26 22:58:13

I'd say island of some kind as well.

Danny Lloyd
2020-03-26 23:01:58

Dead pixels on LCD screen

Andrew Gott
2020-03-26 23:02:25

Holes in the same place on different prints are, no doubt, bad pixels on the LCD. Test the screen.

Kathy Ogilby Langdon
2020-03-26 23:07:01

Andrew Gott how do we test screen?

Nathan Kopp
2020-03-26 23:45:24

start with basic trouble shooting. remove and clean your vat, make sure no dried resin is stuck to the fep. next examine the screen physically for dried resin. last step would be to go into the tools option on the printer and select uv detection. look for those holes or any anomalies. you can also run the print with out a vat and plate to see if the holes show up.

Nathan Kopp
2020-03-26 23:45:29

good luck

Kathy Ogilby Langdon
2020-03-26 23:58:32

Nathan Kopp

Kathy Ogilby Langdon
2020-03-26 23:58:46

Nathan Kopp

Kathy Ogilby Langdon
2020-03-26 23:59:07

Nathan Kopp

Kathy Ogilby Langdon
2020-03-26 23:59:35

Nathan Kopp does this looks like a bad lcd?

Nathan Kopp
2020-03-27 00:10:47

Kathy Ogilby Langdon does not look normal. anycubic screens are a consumable so you can do two things. replace it or: ive heard sometimes the cable seating comes loose and needs to be pushed back in.

Nathan Kopp
2020-03-27 00:11:18

should be a nice bright square

原文網址 Kathy Ogilby Langdon
2020-03-26 22:38:51

Would this work as a FEP replacement for Anycubic Photon? Fep Replacement Sheets Size .2mm - Pack Of 3 - Wanhao Duplicator

翻譯年糕

原文網址 Kathy Ogilby Langdon
2019-12-29 03:42:21

My son has the Ender 3. (He bought it with grass moving money last year.) We are considering upgrading to the Photon as a 14yr old bday gift. He mainly prints D&D miniatures and the Ender 3 is ok, but leaves a lot to be desired. I'm concerned about the resin safety in the house. We do not have a garage. Live in central Florida, so not too cold or hot right now. Could we set up the printer on a covered screened in porch? Does anyone do that? Is there a recommended room temp & humility for the resin printers?

翻譯年糕

Bryson Gabriel Taylor
2019-12-29 03:45:32