Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Adrian Andrei Vulpe
2019-04-10 19:32:37

It seems I have an issue with my prints.
After 1st print the second one has issues with connectig the support to the objectsand some of them fall into the tray or are connected but they wobble during the print, thus turning out bad. What could be the problem?

I print a tray of 6 pices on it with default settings. It takes about 1h 30 min to print and after I remove the parts from the plate I start printing again.

翻譯年糕

Mark Markleson
2019-04-10 19:35:02

Adrian Andrei Vulpe
2019-04-10 19:35:46

Adrian Andrei Vulpe
2019-04-10 19:36:11

Mark Markleson
2019-04-10 19:37:11

Adrian Andrei Vulpe
2019-04-11 02:35:46

原文網址 Adrian Andrei Vulpe
2019-04-10 00:38:48

NOOB question :

Now I print at 0.03 layer thikness. What are the benefits of printing at 0.01? NOOB question :

Now I print at 0.03 layer thikness. What are the benefits of printing at 0.01? 翻譯年糕

Simonffy Csaba
2019-04-10 00:42:38

Simonffy Csaba
2019-04-10 00:43:15

Tyler Bryant
2019-04-10 00:44:04

Damian Marcela Glinojecki
2019-04-10 00:48:14

Bob Pattenden
2019-04-10 00:49:44

Stefan Giudici
2019-04-10 00:50:27

Adrian Andrei Vulpe
2019-04-10 01:05:39

Dustin Scott
2019-04-10 01:15:23

Markus Schönfelder
2019-04-10 01:17:59

陳小鎬
2019-04-10 01:18:19

Zena Andreou
2019-04-10 01:19:11

Timmo Hellemann
2019-04-10 01:23:03

Guti Gutmann
2019-04-10 02:21:46

Dustin Scott
2019-04-10 03:31:18

Andy Lokman
2019-04-10 04:17:12

Andy Lokman
2019-04-10 04:17:32

Timmo Hellemann
2019-04-10 04:20:01

Keith Holmes
2019-04-10 04:34:26

Andy Lokman
2019-04-10 04:54:48

Dustin Scott
2019-04-10 05:26:50

Scott Hammond
2019-04-10 06:40:30

Adrian Andrei Vulpe
2019-04-10 06:44:17

Nathan Rich
2019-04-10 14:18:43

Stefan Giudici
2019-04-10 14:25:37

原文網址 Adrian Andrei Vulpe
2019-04-09 20:35:11

Hello guys!
At this moment I have a DIY made curing booth and would want to buy a profi one.
What curing booth do you have and what do you recomend buying?

翻譯年糕