Anycubic Photon Printer Owners 造訪社團 » 用戶發文

What does everyone use to analyze the hz of their FEP? I've tried a few apps but they're really hard to actually see what hz is, or they're inconsistent. This is first time replacing the FEP I've done this or even used a bottle cap to put some slack in it. I'd tuned the best I could to 300hz~ but was getting finished-ish prints that the base Layers were peeling slightly causing some supports to fail. I took a straight edge and noticed some of the screws from the FEP bracket were sticking out past the resin vat, which I assume was causing some leveling issues. I've got it tightened up now and the screws are not sticking out past the vat but the FEP is at like 700hz. I'm also getting wildly different hz results using my finger versus a sharpie on the app I'm using. Should I just get another sheet of FEP and start with more slack than the bottle cap? Or is the audio analyzer I'm using (spectroid) wack?

翻譯年糕

This is driving my OCD wild, can anyone tell me how I got the build panel in Chitubox sideways, and how I can straighten it?

翻譯年糕

Okay,
I tried to look around and find a post on it cause I know I'm not the only jackass whose ever found out they have a small leak in the FEP after leaving resin in the vat for a few days, but I can't find another post on it. From what I remember having the vat filled to before only a small amount leaked out, but enough that I'm worried.

I managed to clean off all the surface resin on the glass cover, but it seems there is some resin in between the glass and the LCD screen. How screwed am I here? Am I better just taking the whole thing apart to make sure there's not resin in the wrong places? How can I best remove the glass cover?

Thanks in advanced all.

翻譯年糕

Hey all,

Just purchased some Siraya resins and from what I can read they have a prime operating temperature of at least 25C. How would I manage to keep the inside of my printer this temp, short of heating my house?

Thanks again all for all your assistance :)

翻譯年糕

Hi all,

Got another question; who has used monocure's Flex resin, or any other branded flex resin? I'm looking to use it mostly just as an additive to make my print's able to survive a good drop, as accident's happen and I know I am prone to them. Is it worth the investment and does it last you a good long time? What ratio should be mixed, and what methodology have you used to mix with existing resin. Also, can you mix with just about any other resin? Thanks all for putting up with all my questions :)

翻譯年糕

Hello all!

So, who has used an ultrasonic bath to finish their prints? Could you explain what the benefits are an what your experience with the process is? Whats the advantage of the ultrasonic bath. Would something like this be worth a purchase?
https://www.amazon.com/dp/B007Q2M17K/ref=nav_timeline_asin…

Thanks all in advance :)

翻譯年糕

Hi all!

So I just got my Anycubic Photon (woot!) and it comes with yellow glass instead of the blue glass that I understood wasn't a UV filter, but is this new yellow glass UV filtered?

Thanks!

翻譯年糕