Hi to all, I would have a question to ask to those who already found themselves with this problem.
I realized, as you can see in the photo, a series of buttons with inscriptions for a 50s vintage car radio.
The printing itself is not a bad thing, using Anycubic Gray Resin, but a number of problems have arisen, as shown in the photos.
In photo number 1, below, marked by the larger ellipses, I found that the floors are deformed, that is they tend to rise outwards, which also happens to me in all the prints. I explained it in photo number 3.
Moreover, again in photo 1, I have highlighted how the resin has exceeded between the upper and lower limits of the numbers and the edges of the buttons until it touches and covers the space that in reality should have been, as shown in the initial project of photo number 2.
The buttons have been printed full.
I have also noticed that by measuring with the gauge, both the width and the depth of each button, is exceeding by at least 0.3 mm.
These are the print settings:
Anycubic Resin Gray
Layer thickness: 0.05
Bottom exposure: 115 sec
Layer bottom: 8
Off time: 6.5 sec
Normal exposure: 18 sec
Ambient temperature, around 22 ° celsius
Anycubic Photon software.
If anyone can tell me some solution, I would be grateful.
翻譯年糕
Paul Churchill
2019-04-10 16:43:37
Mortadella De Mortadellis
2019-04-10 16:44:15
Ivan Antharon Antalec
2019-04-10 16:56:49
Luke Mason
2019-04-10 19:17:10
Robert Silvers
2019-04-10 21:20:12
Mortadella De Mortadellis
2019-04-11 01:14:54
Bradley VanScoyk
2019-04-11 09:44:34
Bradley VanScoyk
2019-04-11 09:47:06
Robert Silvers
2019-04-11 10:06:57
Devin Wallace Simonsen
2019-04-11 11:26:18
Dylan Hancox
2019-04-11 12:46:12
Mortadella De Mortadellis
2019-04-11 14:16:15
Breno Azevedo
2019-04-12 14:09:05
